Produse recomandate

DYNACORD´s SUB 112 is a vented, direct radiating cabinet, equipped with the high-power DYNACORD DND12S400 neodymium transducer. The conical vent system shows significantly less distortion and lower air noise at low frequencies than common circular vent openings.
The SUB 112 contains a passive filter, 6 dB/oct., that suppresses high frequencies. Appropriate fullrange cabinets, e.g. DYNACORD's D 8 can therefore be directly connected in parallel to the SUB 112 if an extended bass reproduction is required. You just have to connect the SUB 112 and the D 8 with a regular Speakon cable in parallel.
The SUB 112 cabinet is made of 15mm birch plywood. All corner joints and braces are grooved and glued. The cabinet´s surface is painted with a 2-K laquer finish . The acoustic foam front on a powder coated steel grille protects the DND12S400 woofer against damage during transport and bad environmental conditions. The connector panel uses two 4-pole Speakon connectors (INPUT/THRU) for a safe connection and easy daisy-chaining to other cabinets. The pin assignment is 1+/1-. Pins 2+ and 2- are also connected between the two Speakon connectors. A pole-mount flange allows easy speaker-on-a-stick applications. Please always take care that every speaker stack has been mechanically secured against accidental falling down. Please always consult a certified structural engineer for correct and safe setup methods.
The cabinet is equipped with four large rubber feet. Two handles allow easy and safe transport. A protective cover is available as an optional accessory.

Order No. D113134
Cabinet Subwoofer Configuration
Built-In Hi-Cut Filter
Nominal impedance 8 Ohms
Rated power RMS 400 Watts
Program power 800 Watts
Peak power 1600 Watts
SPL 2,83 V / 1m 1 W / 8 Ohm 92 dB
Max. SPL 1m (calculated with peak power) 124 dB
Frequency range ( -10dB ) 43Hz - 350Hz
Passive crossover frequency 124 Hz
Component SUB DND12S400
Order No. D366712
Connectors SUB 1+, 1-
Wired through 2+, 2-
Connector model Speakon NL4MPR
Dimensions (WxHxD) mm 445 x 380 x 445 mm
Shipping weight 22 kg
Net weight 20 kg
Enclosure material Birch Plywood
Finish 2-Component Paint
Grille Powder coated steel, Acoustic Foam
Handles 4
Castors 4
Warranty 36 months

link producator http://www.dynacord.com/en/products/7/1/1/180_sub112.html

Specificatiile tehnice si imaginile prezentate au caracter informativ si pot contine erori sau inadvertente. Specificatiile tehnice si pretul produselor pot fi modificate de producator fara preaviz sau pot contine erori de operare si nu constituie obligativitate contractuala.

Preturile sunt exprimate in lei noi si includ TVA. Preturile pot suferi modificari fara o notificare prealabila in functie de variatiile cursului de schimb euro/ron sau usd/ron. Preturile afisate nu creaza o relatie contractuala, ESON declinandu-si responsabilitatea pentru eventualele greseli ale preturilor.

Facem tot posibilul pentru a prezenta fidel toate caracteristicile relevante ale unui produs. In cazul in care descoperiti inadvertente sau omisiuni, va rugam sa ni le comunicati la cs <at> eson.ro. Va rugam nu folositi aceasta adresa pentru trimiterea de oferte comerciale. Implicit aceste oferte sunt nesolicitate si intrati sub incidenta legii 365/2002, art. 22.